Battery Defpoint 12600 mAh 135A (Molicel P42A 21700)

• Capacity: 12600mAh
• Maximum discharge current: 135A
• Maximum charge current: 6A
• Configuration: 6S3P (3x6)
• Cell type: Molicel INR21700-P42A
• Voltage: 22.2V (nominal), 25.2V (maximum charged)
• Cell size: 21700 (21 mm diameter, 70 mm length)
• Power cable: 10AWG, 10cm, silicone - withstands temperatures up to 200 degrees.
• Power connector: Amass XT60H-F, material - nylon
• Balancing cable: 20AWG, 7cm, silicone - withstands temperatures up to 200 degrees.
• Balancing connector: XH2.54 7-pin

• High capacity: 12600mAh provides long-lasting drone performance, allowing you to enjoy flying without the need for frequent recharges.
• High performance: Maximum discharge current of 135A ensures stable performance even under high loads.
• Reliability: Made of high-quality Molicel INR21700-P42A cells, this battery has a long service life and high resistance to damage.
• High build quality: Thanks to careful production control and the use of high-quality components, the battery has increased reliability and resistance to mechanical stress.

• First, we select and sort the cells by internal resistance
• We glue insulating rings on each battery to prevent short circuits
• We mount the batteries in a plastic case for durability and protection against short circuits
• We weld the cells together using a powerful welding machine. We use a nickel-plated or copper strip with a width of 10 mm and a thickness of 0.2 mm to 0.4 mm as a connection.
• The next step is to solder the power cables (10AWG or 12AWG, depending on the current strength of the assembly) with an XT60H-F connector and the balancing cables with an XH2.54 7-pin connector. After soldering, all cables are laid flat along the assembly so that they do not rub against each other and cause a short circuit during battery use.
• We insulate all exposed elements and parts of the assembly with a layer of insulating cortex and additionally fasten all elements with reinforced, high-temperature adhesive tape.
• After reliable isolation of all internal elements and open contacts, the assembly is packed in two layers in shrink film. We usually use blue or black film, but we can use any other color if necessary.
• The last and one of the most important steps is to check the finished assembly and balance all internal elements to the same value of 3.7 volts. If necessary, we can charge the assembly to 100% for further use.

An ideal choice for those looking for a powerful, reliable and well-built battery for their FPV drone. With Molicel P42A, your drone will always be ready for new challenges and successful flights!